Overview
This Kyosho turnbuckle rod set supplies the servo linkage for the Inferno MP10 series. The rod connects the steering servo to the servo saver and is supplied in a two-piece pack, sized 3x36.
Because the rod is a turnbuckle type, its length can be adjusted while it is still attached to the vehicle, so steering geometry can be trimmed between runs without stripping the front end down.
Key Features
- 3x36 turnbuckle rods supplied as a 2-piece set
- Turnbuckle construction allows length adjustment in place
- Links the steering servo to the servo saver
- Genuine Kyosho spare part for the Inferno MP10 series
Performance Benefits
- Fine steering linkage adjustment without removing the rod
- Restores correct servo geometry after an impact
- Consistent, repeatable steering response
- Removes slop from the servo linkage
Usage Notes
- Thread both ends into the ball ends evenly so engagement matches at each end
- Use a turnbuckle wrench on the flats to avoid marring the rod
- Re-check steering trim and travel after any length change
- Inspect rods and ball ends for bends after heavy crashes
Technical Specs
- Brand: Kyosho
- Item No.: KYO97008-36
- Part: Servo turnbuckle rod
- Size: 3x36
- Quantity: 2 pcs
- Type: Adjustable turnbuckle linkage
- Platform: Kyosho Inferno MP10 series
- Scale: 1:8
What's Included
Fitment
Compatible RC vehicles: Kyosho Inferno MP10 series 1:8 nitro buggies.
Summary
- Genuine Kyosho servo linkage for the Inferno MP10 series
- Turnbuckle design adjusts while installed on the car
- Supplied as a two-piece 3x36 set
- Direct replacement for the factory servo rod