Overview
Replace bent or kinked control linkages with this genuine Rage R/C Push Rod Replacement Set. Sized and shaped specifically for the Spitfire BL 500mm 4-channel control surfaces (ailerons, elevator, and rudder), these OEM pushrods preserve original throw geometry and trim authority.
Hard landings, transport bumps, or simple wear-and-tear can leave pushrods slightly bent — and even small bends affect trim and control response. This set restores factory-correct linkages in minutes.
Key Features
- Complete pushrod set for the Spitfire BL 500mm
- Pre-formed Z-bends and clevis ends to OEM spec
- Correct length for ailerons, elevator, and rudder
- Drop-in replacement — no cutting or fitment required
Performance Benefits
- Restores precise control surface response
- Eliminates flutter and trim drift caused by bent rods
- Saves you the time and risk of fabricating from raw wire
Usage Notes
Re-trim after installation. Inspect clevises for tight engagement and add a small piece of fuel tubing as a clevis keeper if not already present. Always verify control direction before flight.
Technical Specs
- Part: Push Rod Replacement Set
- Pre-formed for: Aileron, elevator, rudder
- Manufacturer: Rage R/C (genuine OEM)
- Condition: New
Fitment
- Rage R/C RAF Spitfire BL 500mm RTF Warbird, Rage R/C RAF Spitfire BL 500mm RFRT Warbird
What's Included
- Push rod set as pictured (aileron, elevator, rudder linkages)
Summary
OEM Spitfire BL 500mm pushrod set — pre-bent, correctly sized, and ready to drop in for clean, slop-free 4-channel control.