Overview
This is the factory replacement control board for the Rage R/C Micro B-25. It is the onboard electronics unit the aircraft is built around, taking the signal from the three-channel transmitter and driving the model's control functions.
Onboard electronics in a micro warbird sit right where the impact loads go in a nose-first landing, and moisture from damp grass can finish off a board that survived the crash itself. Fitting a fresh unit is usually the difference between a grounded airframe and a flyable one.
Key Features
- Genuine Rage R/C replacement part for the Micro B-25
- Factory onboard control board for the three-channel system
- Matched to the Micro B-25 airframe and its transmitter
- Drop-in replacement for the original board
- Lets you rebuild rather than replace a damaged aircraft
Performance Benefits
- Restores full onboard control after electronics damage
- Factory-matched unit avoids compatibility guesswork with third-party electronics
- Correct fit keeps the installation light and properly balanced
- Keeps a well-flown B-25 in service at a fraction of a new aircraft's cost
Usage Notes
- Disconnect the flight battery before removing or fitting the board
- Note the original lead routing and plug positions before unplugging anything
- Secure the board in its original location so the balance point is unchanged
- Re-link the aircraft to its transmitter and check every control before flying
Technical Specs
- Brand: Rage R/C
- Item No.: RGRA1814
- Part type: Replacement control board
- System: 3-channel
- Fits: Rage R/C Micro B-25
What's Included
- (1) Control board for the Micro B-25
Fitment
Compatible RC vehicles: Rage R/C Micro B-25
Summary
- Factory control board for the Rage R/C Micro B-25
- Restores onboard control after crash or moisture damage
- Drop-in fit with the standard Micro B-25 airframe and transmitter
- A practical repair part instead of replacing the whole aircraft
