Tekin Titanium Power Cell 2S Shorty ULCG LiPo Battery 140C (7.4V/4200mAh) w/5mm Bullets TT1655

Titanium Power Cell LiPo Battery Overview:

Elevate your RC car's performance with the Tekin Titanium Power Cell LiPo Battery. This cutting-edge battery, crafted by Tekin, integrates industry-leading technology to enhance your vehicle's power delivery and handling, ensuring a competitive edge on the track.

Features:

• Shorty ULCG Design: Low center of gravity improves car handling
• Tekin Titanium Cells: Provide ultra-low-resistance and superior performance
• 140C Discharge Rate: Delivers power precisely as needed
• 5mm High Power Bullet Connectors: Gold plated for low resistance and maximum current
• Hard Box Housing: Protects cells and connector terminals

IMPORTANT LITHIUM POLYMER SAFETY INFORMATION

• DO NOT leave a battery in your model when charging
• DO NOT leave lithium batteries unattended when charging
• ALWAYS balance charge lithium battery
• ALWAYS use a LiPo Safe charging bag/box
• YOU MUST use a Li-Poly specific charger to charge lithium batteries (NiMH or NiCD only chargers WILL NOT WORK!)
• YOU MUST not over discharge lithium battery packs
• READ & UNDERSTAND the instructions carefully before operating this battery

NOTE: When using high energy Li-Polymer Batteries, please do not over-discharge or over-charge batteries as this will result in overheated batteries. Discharging capacity can't exceed 80% of the max capacity of the pack after full charging to ensure a good cycle performance. It is recommended to fully charge a brand new battery before using and only discharge the battery 50% for the first 5 cycles. Always monitor race time and/or set a low voltage warning on ESC (End voltage cannot be lower than 3.2v per cell). Do not use a battery that has too low a voltage. Do not expose batteries to sunshine or store/charge batteries at temperatures above 35°C or in a closed car. The high-temperature environment could cause damage to the pack or make it burst. If the battery becomes hot while fast charging, high current discharging, or racing, do not charge it until it has cooled completely. Wait about 20 mins, then inspect prior to recharging.