Overview
TKR1609 is Tekno RC's pack of short M3x3mm set screws, supplied ten to a bag with a black finish. These are the tiny grub screws that lock Tekno's clamping hardware in place, and they are easy to lose during a rebuild.
Tekno specifies this screw for the TKR5571M 12mm clamping hexes, the TKR5199A CNC rear hubs for the EB48, NB48, ET48 and NT48 platforms, and the TKR5336B NB/NT throttle linkage. If you run any of those parts, this is the correct replacement hardware.
Key Features
- M3 x 3mm set screw (grub screw) with hex socket drive
- Black finished steel hardware
- Ten screws per pack
- Specified for TKR5571M clamping hexes, TKR5199A CNC rear hubs and TKR5336B throttle linkage
- Short length sits flush in clamping components
Performance Benefits
- Locks clamping hexes to the axle so the wheel drive stays positive
- Keeps CNC rear hub hardware secure through hard landings
- Holds throttle linkage adjustment where you set it
- Fresh sockets accept the driver fully, so small screws do not round out
Usage Notes
- These screws are small; use a precise metric hex driver and seat it fully
- Threadlock is recommended on clamping hex and linkage set screws
- Do not overtighten, as the short screw body offers little thread engagement
- Check the screws after the first runs following installation
Technical Specs
- Brand: Tekno RC
- Item No.: TKR1609
- Type: Set screw (grub screw)
- Thread: M3 metric
- Length: 3mm
- Finish: Black
- Quantity: 10 pieces
- Country of Origin: Taiwan
What's Included
- (10) M3x3mm set screws, black
Fitment
Compatible RC vehicles: Used on Tekno RC TKR5571M 12mm clamping hexes, TKR5199A CNC rear hubs for the EB48, NB48, ET48 and NT48 platforms, and the TKR5336B NB/NT throttle linkage. Fits any vehicle running those Tekno components.
Summary
- Genuine Tekno RC M3x3mm set screws, ten per pack
- Correct hardware for clamping hexes, CNC rear hubs and throttle linkage
- Covers the Tekno EB48, NB48, ET48 and NT48 1/8 platforms
- Small, easy-to-lose part worth stocking as a spare
