Overview
This hardened steel MOD1 clutch bell is intended to be used with the Tekno RC Traktion Drive system. It comes with bearings and carries 13 teeth, so you can set your final drive ratio without pulling the spur gear out of the car.
Hardened steel is the right material for the job. A clutch bell lives in the hottest, highest-rpm part of a 1/8 scale drivetrain and absorbs the full load of every clutch engagement, and a steel bell holds its tooth profile far longer than a softer alternative.
Key Features
- 13 tooth count with a MOD1 tooth profile
- Hardened steel construction for long service life
- Supplied with bearings
- Designed for the Tekno RC Traktion Drive clutch system
- Also compatible with most nitro three shoe clutch systems
Performance Benefits
- Swapping clutch bells is the quickest way to adjust gear ratio at the track
- Hardened steel resists tooth wear from heat and clutch load
- Included bearings keep the bell spinning freely for clean engagement
- Consistent tooth profile keeps spur gear mesh predictable as the part wears in
Usage Notes
- Not compatible with Tekno RC nitro vehicles or most other four shoe clutches
- Compatible with most other nitro three shoe clutch systems
- Must be paired with a MOD1 spur gear
- Set gear mesh with a small amount of backlash and keep the bearings clean and oiled
Technical Specs
- Brand: Tekno RC
- Item No.: TKR4123
- Tooth count: 13T
- Gear pitch: MOD1
- Material: hardened steel
- Bearings: included
- Scale: 1/8
- Country of origin: Taiwan
What's Included
- (1) 13T MOD1 hardened steel clutch bell
- (1) set of clutch bell bearings
Fitment
Compatible RC vehicles: 1/8 scale vehicles using the Tekno RC Traktion Drive clutch system, plus most nitro three shoe clutch systems. Not compatible with Tekno RC nitro vehicles or most four shoe clutches.
Summary
- 13T MOD1 clutch bell machined from hardened steel
- Bearings included and ready to install
- Built for Traktion Drive and most three shoe nitro clutches
- Fast, reliable way to change final drive ratio
