Overview
This hardened steel MOD1 clutch bell is intended to be used with the Tekno RC Traktion Drive system. It comes with bearings and carries 15 teeth, placing it in the middle of the Tekno RC clutch bell range.
Hardened steel is the right material for the job. A clutch bell lives in the hottest, highest-rpm part of a 1/8 scale drivetrain and absorbs the full load of every clutch engagement, and a steel bell holds its tooth profile far longer than a softer alternative.
Key Features
- 15 tooth count with a MOD1 tooth profile
- Hardened steel construction for long service life
- Supplied with bearings
- Designed for the Tekno RC Traktion Drive clutch system
- Also compatible with most nitro three shoe clutch systems
Performance Benefits
- Swapping clutch bells is the quickest way to adjust gear ratio at the track
- Mid-range tooth count suits a broad mix of track layouts
- Hardened steel resists tooth wear from heat and clutch load
- Included bearings keep the bell spinning freely for clean engagement
Usage Notes
- Not compatible with Tekno RC nitro vehicles or most other four shoe clutches
- Compatible with most other nitro three shoe clutch systems
- Must be paired with a MOD1 spur gear
- Set gear mesh with a small amount of backlash and keep the bearings clean and oiled
Technical Specs
- Brand: Tekno RC
- Item No.: TKR4125
- Tooth count: 15T
- Gear pitch: MOD1
- Material: hardened steel
- Bearings: included
- Scale: 1/8
- Country of origin: Taiwan
What's Included
- (1) 15T MOD1 hardened steel clutch bell
- (1) set of clutch bell bearings
Fitment
Compatible RC vehicles: 1/8 scale vehicles using the Tekno RC Traktion Drive clutch system, plus most nitro three shoe clutch systems. Not compatible with Tekno RC nitro vehicles or most four shoe clutches.
Summary
- 15T MOD1 clutch bell machined from hardened steel
- Bearings included and ready to install
- Built for Traktion Drive and most three shoe nitro clutches
- Fast, reliable way to change final drive ratio
