Overview
This is the angled rear gearbox housing from Tekno RC, molded for use with 5x13x4mm bearings. It carries the rear differential and driveshaft and sets their alignment, so condition matters more than it looks like it should.
Rear gearboxes take the worst of the landings and the rocks. Once bearing pockets wear oversize or the case picks up a crack, the drivetrain loses efficiency and gets noisy. Rebuilding onto a fresh housing restores the alignment the car was designed around.
Key Features
- Angled rear gearbox housing
- Sized for 5x13x4mm bearings
- Molded composite construction for strength and impact absorption
- Direct replacement part for a cracked or worn rear gearbox
Performance Benefits
- Restores correct rear diff and bearing alignment
- Tight bearing pockets reduce slop and uneven gear wear
- Composite housing absorbs impact rather than passing it into the drivetrain
- A fresh case seals the rear diff against dirt and water
Usage Notes
- Confirm your vehicle uses the angled rear gearbox with 5x13x4mm bearings before ordering
- Follow your vehicle's manual for assembly order and screw lengths
- Seat bearings fully and check that the diff spins freely before final assembly
- Do not over-tighten screws into the composite housing
Technical Specs
- Brand: Tekno RC
- Item No.: TKR5016B
- Position: Rear, angled
- Bearing Size: 5x13x4mm
- Material: Molded composite
- Country of Origin: Taiwan
What's Included
- (1) angled rear gearbox housing
Fitment
Compatible RC vehicles: Tekno RC vehicles that use the angled rear gearbox with 5x13x4mm bearings. Check your kit manual or exploded view against this part number before ordering.
Summary
- Angled rear gearbox housing from Tekno RC
- Set up for 5x13x4mm bearings
- Molded composite replacement for crash or wear damage
- Puts rear drivetrain alignment back where it belongs
