Overview
Tekno RC's +4mm wheel hubs are CNC machined from aluminum and anodized in the same gun metal finish used across the Tekno hop-up range. The lightened design trims weight at each corner while keeping the strength needed for 1/8 scale truggy running.
These hubs are a direct replacement for TKR9673 and are intended for use on the ET48 2.0 and NT48 2.0 truggies. Drive pins are included, so the hubs are ready to install with your existing wheels and wheel nuts.
Key Features
- CNC machined aluminum construction
- +4mm offset for added track width
- Lightened design reduces rotating and unsprung mass
- Gun metal anodized finish that matches other Tekno RC parts
- Drive pins included
- Direct replacement for TKR9673
Performance Benefits
- Added offset widens the stance for more stability through fast, rough sections
- Less rotating weight lets the drivetrain accelerate and slow more freely
- Machined aluminum resists the flex and deformation that softer hubs suffer from
- Consistent hub geometry keeps wheels seated squarely for even tire wear
Usage Notes
- Intended for the ET48 2.0 and NT48 2.0 truggy platforms
- Changing offset also changes track width, so re-check your camber and toe settings
- Seat the drive pins fully and snug the wheel nuts before every run
- Inspect the hub bores and pins for wear after hard landings
Technical Specs
- Brand: Tekno RC
- Item No.: TKR5071E
- Material: CNC machined aluminum
- Finish: Gun metal anodized
- Offset: +4mm
- Design: Lightened
- Replaces: TKR9673
- Country of Origin: Taiwan
What's Included
- (1) set of Tekno RC +4mm lightened aluminum wheel hubs
- (1) set of drive pins
Fitment
Compatible RC vehicles: Tekno RC ET48 2.0 and NT48 2.0 1/8 scale truggies. Direct replacement for TKR9673.
Summary
- +4mm lightened aluminum wheel hubs in Tekno's gun metal anodized finish
- Direct TKR9673 replacement for the ET48 2.0 and NT48 2.0 truggies
- Wider track width with less weight out at the wheels
- Drive pins included for a straightforward swap
