Overview
This is the Tekno RC universal center rear driveshaft in the 170.5mm length for the NT48 and NT48.3 nitro truggy. It runs between the center differential and the rear differential, so it carries every bit of power the engine makes and takes the full shock of landings and hard throttle hits.
A universal joint driveshaft transmits power smoothly through its working angle rather than binding like a simple dogbone, which means less driveline vibration and a more consistent feel on power. This is the genuine Tekno RC part in the correct length, so no shimming or guesswork is needed.
Key Features
- Universal joint center driveshaft, rear position
- 170.5mm length for the NT48 and NT48.3 driveline
- Smooth power transfer through the joint's working angle
- Direct replacement, no modification required
- Genuine Tekno RC replacement part
Performance Benefits
- Less driveline vibration than a sliding dogbone setup
- More consistent power delivery to the rear differential
- Reduced wear on the center and rear diff outdrives
- Correct length means proper driveline geometry out of the bag
Usage Notes
- Rear center position only; the front center shaft is a different length
- Keep the universal joint pins and cross clean and lightly lubricated
- Inspect the joint for play after heavy crashes
- Confirm the 170.5mm length matches your chassis before ordering
Technical Specs
- Brand: Tekno RC
- Item No.: TKR5297
- Type: Universal joint driveshaft
- Position: Center, rear
- Length: 170.5mm
- Country of Origin: Taiwan
What's Included
- (1) Universal center rear driveshaft, 170.5mm
Fitment
Compatible RC vehicles: Tekno RC NT48 and NT48.3 nitro truggy, center rear driveshaft position.
Summary
- 170.5mm universal center rear driveshaft for the Tekno NT48 and NT48.3
- Smoother, more consistent center driveline power transfer
- Direct bolt-in replacement in the correct length
- Genuine Tekno RC part
